Diagram: How to make a device like the one in Marknorth’s story ‘The Device’

Marknorth sent this information a while back, about making a device as described in his story The Device. (To read the story, it’s in three parts in Marknorth’s author page in the Prison Library …. click here and scroll down.

Here’s what Marknorth says,

Dear Metal,

Attached is an overview of existing technology that could be easily adapted to create a version of “the device” from my story.

Although not “self-contained” as the one in the story, it would be relatively easy for the chastity slave to carry the transmitter. The range for control is also limited to 7 miles (maximum with no interference), but the GPS tracking ability is wide-ranging.

Obviously, the equipment is for tracking and training dogs, but the idea carries over. The cock-ring modification is one of the smaller rings from my CB6K.

 

And here is Marknorth’s diagram (click to enlarge):

EStim-Trainer

 

 

Our 3D Date – Chapter 2

By Rbbrstorage

Conversation over dinner mostly covered business and sports. I wouldn’t have had much to offer to either topic, so perhaps it was good that I was restrained at the side of the room in a laser-measured and 3D-printed composite exo-skeleton that kept my body entirely motionless from my crotch to my mouth – my ass impaled by an integrated dildo, and my mouth invaded by the open mouth gag that formed the top of the device and covered my teeth – my torso sealed inside a sheath of composite metal with my arms pinned close at my sides – all of it contained in a single piece of near-seamless, flowing and organic design that perfectly fit my body.

Continue reading Our 3D Date – Chapter 2

Overnight in a full body cast

MetalbondNYC_blog_01At Serious Male Bondage, a guy is put in a full body cast. Talk about a serious bondage scene! There is probably nothing more confining than this. Here’s what Mark of Serious Male Bondage has to say:

“The guy was in the cast overnight for 14 hours. He had an internal catheter. He was very comfortable during the night. Because of his extended but bent arms and bent legs, he was able to endure the rigid enclosure. If he were lying flat like a mummy, the fatigue would have set in much sooner. Also, because of the cotton padding, he was able to move around a little inside of the cast. We changed his position from upright to lying down a few times during the night with the use of a hydraulic medical table. He woke up once during the night and because he was disoriented. He started to panic a little, but as soon as he became fully awake he calmed down and was OK for the remaining duration. He didn’t eat any solids for 24 hours before being cast. He drank two bottles of ‘Ensure’ supplement drink with a straw during the 14 hours of confinement. He wants to experience the whole process again and stay in the cast for as long as he can. It took us 2+ hours to cut him out of the cast, so that time needs to be factored into an extended stay time duration. There is no quick release for this process. The round blades of the cast saws do not rotate, they vibrate, so there is little danger of cutting through the subject’s skin. The fiberglass materials for this full body cast cost around $300. The saws cost around $280 each.”

Here are some additional pictures:

MetalbondNYC_blog_02 MetalbondNYC_blog_03 MetalbondNYC_blog_04 MetalbondNYC_blog_05 MetalbondNYC_blog_06 MetalbondNYC_blog_07 MetalbondNYC_blog_08 MetalbondNYC_blog_09 MetalbondNYC_blog_10 MetalbondNYC_blog_11 MetalbondNYC_blog_12 MetalbondNYC_blog_13

A VIDEO of this entire process is available at Serious Male Bondage.

Metalbond would like to thank Mark for sharing these pictures.

male bondage videos