Master Mike describes one of his many cages:
It is hard to tell from the picture, but it is quite small, 28 by 32 inches with solid sides and top and closely spaced bars in the front. It is very confining after a while.
Master Mike writes,
Here is the final piece of my electro magnet setup. I wrote this program that can be run from any PC with internet access. It basically controls the remote timer connected to the electro magnet system. There are two timers, the local timer that cannot be remotely controlled and is currently set to 8 hours, and the remote time that is currently set to 2 hours and can be controlled by the prison guard program. Both timers need to be active for the magnet to be on. The prison guard program can be used to set up cycles to reset the remote timer. It can also be used to optionally set release time after the execution of a number of cycles.
In the example below, the cycle time is set to 32 minutes and set for 7 cycles:
When 3 cycles remain, the program will release the magnet for 2 seconds.
This works out to be a maximum restraint time of 03:44:06 with the earliest possible release of 02:08:00. As you can see in the example below, I slept through the first two early release cycles.
The system is completely safe. The remote time cannot exceed the local time value currently set to 8 hours. If the internet connection is lost, then the remote time will finish out its 2-hour time and release the magnet. In the case of a power failure, the magnet will release.
That being said, there is no other escape.
Only Paul knows the password to access the prison guard program and relay. I cannot clear the timers from my iPad or by calling anyone else to release the timer. The only way I can get out is to call Paul. As for the bed, the left arm is held by the magnet, which has a 1,200-pound hold that is bolted to the floor with the wires running under the carpet. There is no way to pull it off. At the bottom of the magnet block is the key to unlock the restraints. There is absolutely no way to escape. The same system works on the gurney and for the cage.
There is also a camera for the guard to monitor and communicate with the prisoner.
Metal would like to thank Master Mike for sharing this information and sending these pictures!
Master Mike updated his self-bondage apparatus by labeling the timer box he built. He also added a second magnet jack. Here are some pictures:
Metal would like to thank Master Mike for sharing this. Since he sent this batch of pictures, he updated his system further, and additional updates will appear here on Metalbond.
Master Mike was inspired by the timer system made by Louis (see previous post, ‘Self bondage on steroids,’ by clicking here) and he built his own device.
Check out the pictures and information below from this guy:
First off, a big thank you to Louis and the pictures posted on your site of his timer system. I got the same timer units and built myself a timer. I took it one step further and made it controllable over the internet. There are two timers, one I can set for the maximum amount of time before the magnet is released, and the other can be reset or restarted over the internet.
If it is reset, the timer will stop and release the magnet, if it is reset, the timer will reset back to the set time without releasing the magnet. There is also a camera with two-way communications so the remote master can communicate with his prisoner. There are numerous magnets around the house connected to different equipment.
Here are pictures of the timer, internet controller and me secured to the restraint bed.
The magnet has 1200 pounds of holding force and is bolted to the floor, so there is no pulling it free.
Here is a picture of the web page that controls the timer:
Metal would like to thank Master Mike for sharing this information! Very impressive, indeed!
Since he sent these pictures, he subsequently updated his system and sent further updates. Keep checking back to Metalbond to see more about this system.